Showing posts with label Abs light. Show all posts
Showing posts with label Abs light. Show all posts

Wednesday, 1 June 2016

Turn off abs light 1998 nissan frontier

Nissan Frontier ABS Light Will Not Turn OFF

Nissan ABS Light Reset Procedure


It can be a issue with wiring or a problem with ABS control module.
But before you go troubleshooting further,just try the ABS reset Procedure.

""I have a 99' Frontier ,and my Air Bag Light blinks. It started after I hit a bump.
Will this method work for me? ""


Here's the process to reset the air bag light. I tried it and it works.

If you have the airbag light, it will show steady for a few seconds (the manual says 7 secs) after you turn the key from off to on (but not start) and then start to flash. Here is how to reset it:

1. Turn the key from off to on.

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

If it does not work the first time, just repeat the steps again.

Check engine,ABS,air bag light 'ON' 1998 nissan frontier 4x4

1998 Nissan frontier 4x4


How do Iturn off my check engine,ABS,air bag light on 1998 nissan frontier 4x4?

Well since the lights are controlled by the OBD (on board diagnostics), you'll have to reset it. You may be able to do this by simply disconnecting the battery for a few hours. However, a lot of newer vehicles have electronically locked radios which require the manual to be able to be re-enabled.

I'd check out the radio before disconnecting the battery. 

The only other ways are to physically disconnect the lights in the dash or get someone with an OBD reader to clear the codes.

This will help.
Thanks.